![]() ![]() You should choose 6th-7th or 7th-8th pin from NAND bottom on the right side or 6th-7th or 7th-8th pin from first pin (first pin is marked on PCBA with a point or ) and circuit it during plugging to Host PC and powering on (check pin sequence for other devices very clearly)Īfter circuit and attaching to host PC, Android tool will show you message in progress bar: Found one maskrom device. Place PCBA in front of you so you can clearly read NAND’s name and board numberģ. In some boxes you also need detached heatsink or cooler in order to reach NANDĢ. Open device housing and detect NAND (is standalone chip with 48 pins on two sides) on PCBA. Maskrom mode is reflashing way, when you block reading data from NAND using hardware short circuit of NAND pins.ġ. Launch RK DriverAssitant and press “Install Driver”.Īpply all changes and warnings during installation until finishing message Inside archive, you find:īatchTool or Android Tool - tool for reflashingĭriverAssitant - tool to install drivers and firmware image fileĪll actions before reflashing are the same with the The first thing you need is to download the archive with firmware. If you want try to reflash your device for the first time please check THIS article This option can help if your device got soft or hard bricked. ![]() ![]() IMPORTANT: users can perform further manipulations only at their own risk, and only if all other reflashing options can’t help. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |